1.14
Replacing the O-rings of the unit injector
for engines with code BMM
Special tools and workshop equipment required
♦ Assembling sleeves - T10056-
Removing
– Lever off the O-rings from the grooves of the unit injector with
extreme care.
– Make sure, above all, that the contact surfaces in the grooves
for the O-rings are not damaged.
Installing
Note
Always use the assembly sleeves to install the O-rings. If they
♦
are not used there is a risk that the O-rings may become dam‐
aged.
Observe the correct allocation of the O-rings to the slots: The
♦
ring thickness reduces in the direction of the injection nozzle.
Avoid rolling the O-rings when sliding them on. The O-rings
♦
must not be turned inwards on the groove of the unit injector.
– Remove the heat-protection seal along with the circlip.
– Clean the contact surfaces for the O-rings in the grooves of
the unit injector with great care.
– Insert the assembly sleeve - T10056/1- on the unit injector up
to the stop.
– Carefully slide the upper, thicker O-ring onto the assembly
sleeve and in the groove of the unit injector.
– Remove assembly sleeve.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
– Insert the assembly sleeve - T10056/2- on the unit injector up
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
to the stop.
– Carefully slide the middle, thinner O-ring onto the assembly
sleeve and in the groove of the unit injector.
– Remove assembly sleeve.
Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
1. Repairing Diesel Direct Injection system
225