Skoda Octavia II 2004 Workshop Manual page 48

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
– Detach fuel feed line -2- and fuel return-flow line -1-, to do so
press in securing ring.
– Remove top toothed belt guard, to do so release retaining clips
-arrows-.
– Remove ribbed V-belt tensioning device.
– Remove bottom part of right wheelhouse liner ⇒ Body Work
⇒ Rep. gr. 66 .
– Remove crankshaft belt pulley.
– Unscrew bottom and middle toothed belt guard.
Vehicles as of 03.07
– Remove the cooling water tank cover ⇒ Body Work ⇒ Rep.
gr. 66 .
– Fit supporting device - T30099- and base - T30099/1 - , sus‐
pend engine/gearbox assembly from the right lifting eye with
hooks - MP 9-200/10 - and pre-load using spindles, but do not
raise.
Note
If the cylinder head needs to be removed, two spindles must be
attached at the supporting device - T30099-
– Release screws -1- and -2- and remove connecting stud.
– Release screws -3...6- and remove engine mounting.
42
Rep. gr.13 - Crankshaft group
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
⇒ page 85 .