Skoda Octavia II 2004 Workshop Manual page 39

– Release screws -1 ... 3- for engine support and remove sup‐
port.
Note
To release the screws for the engine support, lift or lower engine
slightly via spindle on supporting device - T30099- .
Continued for all vehicles
Caution
The engine may only be turned in the direction of engine rota‐
tion (clockwise) at the crankshaft.
– Rotate crankshaft to TDC for cylinder 1.
• The two tooth segments -arrows- on the camshaft wheels
must both be at the top.
– Lock hubs using rig pins - 3359- .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
– Depending on the version, lock the crankshaft toothed belt with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
sprocket using the crankshaft arrester - T10050- or crankshaft
arrester - T10100- .
Distinguishing the crankshaft toothed belt sprocket:
A = original version of toothed belt sprocket with circular tooth
flanks, rectangular TDC marking on tooth in 12 o'clock position
for cylinder 1 - use crankshaft arrester - T10050 -
B = new version of toothed belt sprocket with elliptical tooth flanks,
triangular TDC marking on the gap in the sprocket in 1 o'clock
position - use crankshaft arrester - T10100-
Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
1. Disassembling and assembling engine
33