Installation Locations For Engines With Code Bmm - Overview - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
Installing
Note
Always use the assembly sleeves to install the O-rings. If not
♦
used, the O-rings may be damaged.
Pay attention to the correct assignment of the O-rings to the
♦
grooves.
Slide on the O-rings during assembly, do not roll. The O-rings
♦
must not be twisted in the seat of the unit injector.
– Clean the contact surfaces for the O-rings in the unit injector
with great care.
– Insert the assembly sleeve - T10164/1- on the unit injector up
to the stop.
– Carefully slide the top, thicker O-ring onto the assembly sleeve
and into the groove on the unit injector.
– Remove assembly sleeve.
– Insert the assembly sleeve - T10164/2- on the unit injector up
to the stop.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
– Carefully slide the lower O-ring with white marking onto the
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
assembly sleeve and into the groove on the unit injector.
– Remove assembly sleeve.
– Install the unit injector
1.9

Installation locations for engines with code BMM - overview

Note
Some components are mounted under the engine cover.
♦
Remove engine cover
♦
The components A through G are not represented in the overview
figure.
216
Rep. gr.23 - Mixture preparation - injection
⇒ page 210 .
⇒ page 13 .