Removing And Installing Radiators For Engines With Code Bkd, Azv - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
– Remove the air filter with air guide hose from the lock carrier
⇒ page 208 .
– Remove noise insulation ⇒ Body Work ⇒ Rep. gr. 50 .
– Disconnect plug -2- from charge pressure sender - G31- / in‐
take air temperature sender - G42- .
– Release screw -4-.
– Remove charge air pipe with connecting hose; to do so raise
the retaining clips -1- and -3-.
– Disconnect plug connection -1-.
– Remove screws -arrows- and take out fan shroud downwards.
Installing
Installation occurs in reverse order to removal. Pay attention to
the following:
♦ Tightening torques:
1.6 Removing and installing radiators for
engines with code BKD, AZV
Special tools and workshop equipment required
♦ Catch pan for workshop cranes , e.g. -VAS 6208-
♦ Pliers for spring-type clips
Removing
– Switch off ignition and pull out ignition key.
Note
Collect drained coolant in a clean container for proper disposal or
reuse.
WARNING
When opening the coolant expansion reservoir, hot steam or
hot coolant may escape. Cover the cap with a cloth and open
carefully.
– Open the cap of the coolant expansion reservoir.
– Remove fan shroud for radiator fan - V7- and right radiator fan
- V35 - ⇒ page 137
– Remove connecting hose from the right charge air pipe; To do
this, raise retaining clips.
138
Rep. gr.19 - Cooling
⇒ page 129
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�