Skoda Octavia II 2004 Workshop Manual page 56

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
– To guide the gasket ring extractor screw the central screw for
crankshaft - toothed belt sprocket in the crankshaft up to the
stop.
– Turn inner part of gasket ring extractor - MP 1-226- two turns
(approx. 3 mm) out of the outer part and lock with knurled
screw.
– Oil the thread head of the sealing ring extractor, position and
fix screw into the sealing ring as far as possible.
– Release knurled screw and turn the inner side against the
crankshaft until the gasket ring is pulled out.
– Clamp gasket ring extractor into the vice and remove gasket
ring with pliers.
– Clean the contact and sealing surfaces.
Installing
Note
Do not oil the sealing lip and the outer surface of the gasket ring
before the pressing in procedure.
– Remove oil residue on the crankshaft journal with a clean
cloth.
– Insert guide bushing - T10053/1- on the crankshaft bearing
pin.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
– Slide gasket ring over the guide bushing.
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
50
Rep. gr.13 - Crankshaft group