Skoda Octavia II 2004 Workshop Manual page 61

A - Mounting sealing flange with rotor on the assembly tool -
T10134-
A - Hexagon nut
B - Clamping surface
C - Assembly cup
D - Allan screw
E - Guide bolts (with red handle - for fuel engine)
F - Positioning pin
G - Guide bolts (with black handle - for diesel engine)
– Grip the assembly tool - T10134- on the clamping surface
-B- of the threaded spindle in a vice.
– Remove securing clip -arrow- from new sealing flange.
Note
Do not remove the rotor from the sealing flange or turn it.
– Place sealing flange with front side facing down on a clean
level surface.
– Press the sealing lip supporting ring -A- -arrows-, until it rests
on the level surface.
• The top edge of the rotor and the front edge of the sealing
flange must be flush.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
2. Removing and installing sealing flange and flywheel
55