Skoda Octavia II 2004 Workshop Manual page 66

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
Continued for all
– Rotate the secondary side -A- of the two-mass flywheel in such
a way that the screws -B- are positioned in the middle of the
holes -arrows-.
Caution
When unscrewing the screws -B-, ensure that no screw head
catches on the secondary side -A- of the two-mass flywheel,
otherwise it will be damaged.
– Release screws -B- and remove two-mass flywheel.
Installing
Installation occurs in reverse order to removal. Pay attention to
the following:
Note
Use new screws for attaching.
– Rotate the secondary side -A- of the two-mass flywheel in such
a way that the screws -B- are positioned in the middle of the
holes -arrows-.
1. Screw in all the screws -B- by hand.
2. First of all tighten all the screws -B- crosswise to 60 Nm.
3.
Then torque all the screws -B- crosswise a further 90° (
turn.)
60
Rep. gr.13 - Crankshaft group
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
1
/ 4