Skoda Octavia II 2004 Workshop Manual page 53

– Loosen screws -arrows- for toothed belt sprocket.
– Rotate crankshaft in direction of engine rotation until the crank‐
shaft can be locked in the hole in the sealing flange -arrow-
with the crankshaft arrester .
Note
The stud -arrow- must latch into the bore on the sealing flange.
♦
If the crankshaft has turned behind the TDC for cylinder 1, turn
♦
crankshaft back slightly and once again set to the TDC for cyl‐
inder 1 by turning in direction of rotation of engine.
– Tighten fixing screws -arrows- to 25 Nm.
– Remove locking pin - 3359- and crankshaft arrester - T10050-
or crankshaft arrester - T10100 - .
– Rotate the crankshaft 2 turns in the direction of running of the
engine until the crankshaft is positioned again on TDC for cyl‐
inder 1.
– Repeat timing test ⇒ page 46
Further installation
Further installation occurs in reverse order to removal.
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
1. Disassembling and assembling engine
47