Skoda Octavia II 2004 Workshop Manual page 132

2.0/100; 103 kw tdi pd engine
Hide thumbs Also See for Octavia II 2004:
Table of Contents

Advertisement

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
– Unscrew the bolts of oil pan/gearbox -arrows-.
– Loosen bolts -1...20- crosswise and release.
– Remove oil pan, if necessary release by applying slight blows
with a rubber-headed hammer.
Installing
Installation occurs in reverse order to removal. Pay attention to
the following:
WARNING
Wear protective gloves and goggles when working with gasket
remover and degreasing agent!
– Remove residual sealant from the sealing surfaces on the cyl‐
inder block and on the oil pan with chemical sealant remover.
– Degrease the sealing surfaces.
– Cut off nozzle tube at the front marking (∅ of nozzle approx.
3 mm).
– Apply silicone sealant bead -arrow- to the clean sealing sur‐
face of the oil pan, as shown.
Thickness of sealant bead: 2-3 mm
Note
The sealant bead must not be thicker than 3 mm otherwise
excess sealant may get into the oil pan and clog the strainer
in the oil suction pipe.
Take particular care when applying the sealant bead in the
area of the rear sealing flange -arrows-.
The oil pan must be installed within 5 minutes after applying
the silicone sealant.
– Fit on oil pan immediately and tighten the bolts as follows:
– First of all pre-tighten screws -1...20- crosswise to 5 Nm.
– Tighten the bolts of the oil pan/gearbox -arrows- to a torque of
40 Nm.
– Tighten screws -1...20- crosswise to 15 Nm.
Note
When installing the oil pan with the engine removed, ensure
that the oil pan is flush with the cylinder block at the flywheel
side.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
Let sealant dry for approx. 30 minutes after installing oil sump.
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Only then fill with engine oil.
– Fill with engine oil and check the oil level ⇒ Maintenance ;
Booklet Octavia II .
126
Rep. gr.17 - Lubrication

Advertisement

Table of Contents
loading

This manual is also suitable for:

Octavia ii 2010

Table of Contents