Skoda Octavia II 2004 Workshop Manual page 28

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
– Move the engine/gearbox assembly with an assembly lever
between engine support -1- and supporting arm -3- for engine
mount until the following dimensions are set:
• Between engine bracket and engine support there must be a
distance -a- of 10 mm.
• The cast iron edge on the engine support -2- must be parallel
to the supporting arm -1- the dimension -x- must be the same
at the front and rear.
Note
The distance -a- = 10 mm can be checked e.g. with suitable round
bars.
– Tighten screws for engine assembly bracket
– Make sure that on the gearbox side the edges of the support‐
ing arm -2- and gearbox support -1- are parallel.
• The dimension -x- must be the same on both mount sides.
– Tighten screws for gearbox assembly mounting
Further installation occurs in reverse order.
22
Rep. gr.10 - Removing and installing engine
⇒ page 19
⇒ page 19
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
.
.