Skoda Octavia II 2004 Workshop Manual page 189

Removing
– Remove steering column trim panel -arrows-.
– Lever out the cap ( ⇒ page 182
– Unscrew fixing screw (
– Push the release tool - T10238- (for right-hand drive release
tool - T10240- ) as shown up to the stop into the provided
openings and remove the accelerator pedal module.
– Disconnect connector from accelerator pedal module. To do
so press down securing element from connector.
Installing
– Fit the plug -2- onto the accelerator pedal module -5-.
The locking of the connector must be audible.
– Push accelerator pedal module onto the securing bolt -6-.
– Insert the centering pin -7- into the hole in the underbody.
– Screw the accelerator pedal module with the fixing screw -3-,
tighten to 10 Nm and fit on the cap -4-.
– Install steering column cover.
– If the accelerator pedal module was replaced, the engine con‐
trol unit has to be adapted ⇒ Vehicle diagnostic tester.
– On vehicles with automatic gearbox, adapt the kick-down
function after replacing the accelerator pedal module ⇒ Vehi‐
cle diagnostic tester.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Pos. 4) with a screwdriver.
⇒ page 182 , Pos. 3).
Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
183
2. Accelerator control