Skoda Octavia II 2004 Workshop Manual page 174

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
– Unlatch and disconnect the plug connection of the lines -1-
(brown), -2- (blue) and -3- (black).
– Raise securing tabs -4- and -5- with a screwdriver and remove
the fuel gauge sender - - downwards -arrow-.
Installing
– Insert the fuel gauge sender - G- into the guides on the fuel
delivery unit and press upwards until it engages.
– Connect the wiring and check correct installation of the plug.
– Install fuel delivery unit.
♦ Vehicles with front-wheel drive:
♦ Vehicles with four-wheel drive:
Fuel gauge sender - G- type 2
Removing
– Remove fuel delivery unit.
♦ Vehicles with front-wheel drive:
♦ Vehicles with four-wheel drive:
– Unlock the securing tabs -arrows- using a screwdriver and pull
the fuel gauge sender - G- up and out.
– Unlatch and disconnect the plug connection of the lines -1-
(brown), -2- (blue) and -3- (black).
Installing
– Connect the wiring and check correct installation of the plug.
– Insert the fuel gauge sender - G- into the guides on the fuel
delivery unit and press down until it engages.
– Install fuel delivery unit.
♦ Vehicles with front-wheel drive:
♦ Vehicles with four-wheel drive:
168
Rep. gr.20 - Fuel supply system
⇒ page 161
⇒ page 162
⇒ page 161
⇒ page 162
⇒ page 161
⇒ page 162
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�