Skoda Octavia II 2004 Workshop Manual page 58

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
– Remove the crankshaft toothed belt sprocket; to do so, hold
toothed belt sprocket with counterholder - T30004 - or lock with
counterholder - MP 1-310- .
– Drain engine oil ⇒ Maintenance ; Booklet Octavia II .
– Removing the oil pan
– Unscrew the fixing screws of the front sealing flange and re‐
move sealing flange, if necessary release by applying slight
blows with a rubber-headed hammer.
– Drive out the gasket ring from the removed sealing flange.
Installing
Installation occurs in reverse order to removal. Pay attention to
the following:
WARNING
Wear protective gloves and goggles when working with gasket
remover and degreasing agent!
– Use chemical sealant remover to remove any sealant residues
from sealing surfaces on sealing flange, cylinder block and oil
pan.
– Degrease the sealing surfaces.
Note
Pay attention to the use by date on the silicone sealant.
– Cut off nozzle tube at the front marking (∅ of nozzle approx.
3 mm).
52
Rep. gr.13 - Crankshaft group
⇒ page 125 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�