Replace Sealing Flange On The Gearbox Side - Skoda Octavia II 2004 Workshop Manual

– Apply silicone sealant bead -arrow- to the clean sealing sur‐
face of the upper part of the sealing flange, as shown.
• Thickness of sealant bead -arrow-: 2...3 mm.
Note
The sealant bead must not be thicker than 3 mm otherwise
♦
excess sealant may get into the oil pan and clog the strainer
in the oil suction pipe.
The sealing flange must be installed within 5 minutes after ap‐
♦
plying the silicone sealant.
When installing the sealing flange with the gasket ring fitted
♦
place a guide sleeve - T10053/1- on the crankshaft journal.
– Carefully push the sealing flange onto the dowel sleeves at the
cylinder block and tighten new fixing bolts by hand.
– Tighten the screws of the sealing flange alternately and cross‐
wise to 15 Nm.
– Insert new sealing ring
– Installing the oil pan
– Remove the crankshaft toothed belt sprocket; to do so, hold
toothed belt sprocket with counterholder - T30004 - or lock with
counterholder - MP 1-310- .
– Installing the timing belt.
♦ Motor code BKD, AZV:
♦ Engine code BMM:
– Top up with engine oil and check the oil level ⇒ Maintenance ;
Booklet Octavia II .
2.3 Replace sealing flange on the gearbox
side
Special tools and workshop equipment required
♦ Assembly tool - T10134-
♦ Screw M6 x 35 (3x)
♦ Screw M7 x 35 (2x)
♦ Feeler gauges
♦ Steel straightedge
2.3.1 Removing
• Gearbox removed.
– Remove the two-mass flywheel
⇒ page 49 .
⇒ page 125 .
⇒ page 26
⇒ page 38
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
⇒ page 59
Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
.
2. Removing and installing sealing flange and flywheel
53