Skoda Octavia II 2004 Workshop Manual page 62

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
The locating hole -B- on the rotor -C- must be flush with the mark‐
ing -A- on the sealing flange.
– Lay the sealing flange with the front side on the assembly tool
- T10134- in such a way that the positioning pin -A- engages
into the hole -B- of the rotor.
Note
Make sure the sealing flange lies flat on the assembly device.
– When tightening the knurled screws -A- press the sealing lip
supporting ring -B- on the surface of the assembly tool -
T10134- in such a way that the positioning pin can no longer
slide out of the rotor hole.
B - Mounting the assembly tool - T10134- with sealing flange on
the crankshaft flange
• The crankshaft flange must be free of grease and oil
• Crankshaft is at TDC for cylinder 1
– Unscrew hexagon nut up to the end of the threaded spindle.
– Screw assembly tool - T10134- with Allan screws -A- up to the
stop onto the crankshaft flange.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
56
Rep. gr.13 - Crankshaft group