Skoda Octavia II 2004 Workshop Manual page 129

10 - O-ring
❑ replace
11 - Intake manifold
❑ Clean strainer if dirty
12 - Baffle
13 - Oil pan
❑ Removing and installing
❑ install with silicone sealant - D 176 404 A2-
14 - Drain plug, 30 Nm
❑ with sealing ring
❑ replace
15 - 10 Nm
❑ replace
16 - Oil level and oil temperature sender - G266 -
❑ Check ⇒ Vehicle diagnostic tester
17 - O-ring
❑ replace
18 - Oil pump
❑ with pressure relief valve 1,2 MPa (12 bar)
❑ Removing and installing
❑ before installing, check whether both dowel sleeves are present
❑ if there is any scoring on the contact surfaces of the gears, replace
❑ Tightening torque of oil pump cover at oil pump housing: 10 Nm
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
19 - Oil pump sprocket
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
❑ Fits onto oil pump shaft in one position only
20 - Bracket at bottom
❑ for the cable to the oil level and oil temperature sender
21 - 15 Nm
22 - 20 Nm + torque a further 90° (
❑ replace
23 - Oil pump chain
❑ before removing mark running direction
❑ check for wear
24 - Sealing flange on the belt pulley side
❑ install with silicone sealant - D 176 404 A2-
❑ replace the gasket ring for the crankshaft - on the belt pulley side
25 - Chain tensioner
❑ do not disassemble
❑ Replace chain tensioner if spring is broken
❑ Check fitting position
❑ When installing, hook on the spring and pretension
❑ tighten to 16 Nm
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
⇒ page 125
⇒ page 127
1
/ 4 turn)
Octavia II 2004 ➤ , Octavia II 2010 ➤
⇒ page 49
1. Removing and installing parts of the lubrication system
123