Skoda Octavia II 2004 Workshop Manual page 76

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
1 - Rear toothed belt guard
2 - Rubber bowl
❑ Replace if damaged.
3 - Pin screw, 10 Nm
4 - Hub
❑ for intake camshaft with
rotor for Hall sender -
G40-
❑ to remove use extractor
- T10052-
5 - 100 Nm
❑ to release and tighten
use counterholder -
T10051 -
6 - Hub
❑ For exhaust camshaft.
❑ to remove use extractor
- T10052-
7 - 10 Nm
❑ insert using locking
agent - D 000 600 A2-
8 - Valve-lever shaft
❑ Mark the installation po‐
sition of the valve lever.
❑ Do not interchange
❑ Removing and installing
⇒ page 73
❑ Before installation,
check that all ball studs
and O-rings are inserted
in the unit injectors
9 - 20 Nm + torque a further 90° (
❑ replace
❑ pay attention to order for slackening
❑ Pay attention to sequence and procedure when tightening
10 - Gasket for cylinder head cover
❑ replace if damaged or leaking
❑ Press onto spacer sleeves (Pos. 15)
11 - Cylinder head cover
❑ Removing and installing
12 - Screw cap
13 - Gasket
❑ replace if damaged or leaking
14 - Sealing sleeve
15 - Screw with spacer sleeve, 10 Nm
❑ Pay attention to sequence for loosening and tightening
16 - 20 Nm
17 - Cylinder head screw
❑ replace
70
Rep. gr.15 - Cylinder head, valve gear
1
/ 4 turn)
⇒ page 74
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
⇒ page 72
⇒ page 77
⇒ page 72