Skoda Octavia II 2004 Workshop Manual page 33

1 - Cap
❑ for vibration damper
❑ mounted up to 05.05
2 - 10 Nm + torque a further 90°
1
( / 4 turn)
❑ replace
3 - Belt pulley - crankshaft
❑ with vibration damper
❑ can be installed only in
one position
❑ Adjust TDC for cylinder
1 with vibration damper
installed ⇒ page 29
4 - 10 Nm
❑ insert using locking
agent - D 000 600 A2-
5 - 40 Nm + torque a further
1
180° ( / 2 turn)
❑ replace
❑ Observe tightening se‐
quence ⇒ page 30
6 - Engine support bracket
❑ From 05.05, the engine
support is installed with
a different mount
⇒ page 30
7 - Top toothed belt guard
❑ when installing in tooth‐
ed belt guard, carefully
insert middle part
8 - Middle toothed belt guard
❑ to remove, remove top toothed belt guard and unscrew tensioning device for ribbed V-belt.
❑ Adjust TDC for cylinder 1 with vibration damper installed
9 - Bottom toothed belt guard
1.2.2 Summary of components - part 2
Note
Mark the direction of rotation with chalk or a felt-tip pen before
removing the toothed belt. Reversing the rotation direction of an
already used belt may destroy it.
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
⇒ page 29
1. Disassembling and assembling engine
27