Skoda Octavia II 2004 Workshop Manual page 34

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
1 - 120 Nm + torque a further
1
90° ( / 4 turn)
❑ replace
❑ do not oil
❑ to release and tighten
use counterholder -
T30004 - or counter‐
holder - MP 1-310
(3099)-
2 - 20 Nm
❑ self-locking, replace
3 - Small guide pulley
4 - 20 Nm + torque a further 45°
1
( / 8 turn)
5 - Tensioning pulley
❑ The eccentric of the new
version has an addition‐
al hole for 6 mm hexa‐
gon socket wrench
⇒ page 29
6 - Toothed belt
❑ mark the direction of ro‐
tation with chalk or a felt-
tip pen before removing
❑ check for wear
❑ do not kink
❑ Removing ⇒ page 30
❑ install (set the timing)
⇒ page 35
7 - 25 Nm
8 - Toothed belt pulley, ex‐
haust camshaft
❑ Check fitting position
9 - 25 Nm
10 - Toothed belt pulley, inlet camshaft
❑ Check fitting position
11 - 100 Nm
❑ to release and tighten use counterholder - T10051 -
12 - 100 Nm
❑ to release and tighten use counterholder - T10051 -
13 - Hub
❑ For exhaust camshaft.
❑ to remove use extractor - T10052-
14 - Hub
❑ for intake camshaft with rotor for Hall sender - G40-
❑ to remove use extractor - T10052-
15 - Rear toothed belt guard
16 - Rubber bowl
❑ to remove the Hall sender - G40- (rear toothed belt guard does not have to be removed)
❑ Replace if damaged.
28
Rep. gr.13 - Crankshaft group
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
⇒ page 98
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
⇒ page 98