Skoda Octavia II 2004 Workshop Manual page 157

the opening of the fuel
tank
❑ only moisten the inner seal of the flange with fuel for fitting purposes
15 - Fuel pump
❑ with sender for fuel gauge display
❑ Removing and installing
❑ Note installation position on the fuel tank
❑ Check ⇒ page 179
❑ Clean strainer if dirty
❑ removing and installing the sender for fuel gauge
16 - Lock ring - 110 Nm
❑ use wrench -T30101 (3087)- for removing and installing
❑ check for firm seating
17 - Fuel return-flow line
❑ from fuel cooler
❑ clipped in place on fuel tank
❑ check for firm seating
❑ blue
18 - fuel feed line
❑ to fuel filter
❑ clipped in place on fuel tank
❑ check for firm seating
❑ black
19 - Fuel tank lid unit
❑ with rubber bowl
❑ removing and installing ⇒ Body Work ⇒ Rep. gr. 55
Fitting location of the fuel delivery unit
The marking -3- on the flange of the fuel delivery unit points
against the direction of travel.
Note
The fuel delivery unit can only be installed in this position.
Blue or blue marked fuel return-flow line -1-.
Black fuel supply line -2-,
Note
After installing the fuel delivery unit, check whether the feed line
and the return-flow line are clipped correctly in place on the fuel
tank.
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
⇒ page 161
⇒ page 151
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
⇒ page 167
1. Removing and installing parts of the fuel supply system
151