Skoda Octavia II 2004 Workshop Manual page 108

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
– Place frame -T10262- on the bearing bush as shown and
tighten fixing screws SW 10 to 10 Nm.
– Screw in the jacking screws by hand until they touch the cyl‐
inder head bolts.
– Evenly screw in the jacking screws in the sequence -1...4-
shown on the screw heads until the bearing bush has detach‐
ed from the cylinder head.
– Remove bearing frame.
Note
Ensure that the bearing shells of the camshaft are not mixed
♦
up.
Mark assignment of the camshaft bearing shells with water‐
♦
proof marker on the reverse side.
– Take out camshafts.
Installing
Installation occurs in reverse order to removal. Pay attention to
the following:
WARNING
Wear protective gloves and goggles when working with gasket
remover and degreasing agent!
– Remove residual sealant on the bearing frame and cylinder
head using a chemical sealant remover.
– Clean sealing surfaces, they must be free of oil and grease.
– Check if the crankshaft is on TDC for cylinder 1.
• Depending on the version, lock the crankshaft toothed belt
sprocket to TDC for cylinder 1 using either crankshaft arrester
- T10050- or crankshaft arrester - T10100- .
Distinguishing the crankshaft toothed belt sprocket:
A = original version of toothed belt sprocket with circular tooth
flanks, rectangular TDC marking on tooth in 12 o'clock position
for cylinder 1 - use crankshaft arrester - T10050 -
B = new version of toothed belt sprocket with elliptical tooth flanks,
triangular TDC marking on the gap in the sprocket in 1 o'clock
position - use crankshaft arrester - T10100-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
102
Rep. gr.15 - Cylinder head, valve gear
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�