Skoda Octavia II 2004 Workshop Manual page 90

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
Removing
– Remove engine cover
– Pull off hose -2- for crankcase ventilation.
– Pull off the vacuum hose to the vacuum reservoir at the cylin‐
der head.
– Release fuel hoses and coolant hoses at right charge air pipe.
– Remove charge air pipe for intake manifold flap motor -
V157- ; to do so, pull the retaining clips
Note
Coolant hoses as well as fuel lines remain connected.
– Remove top toothed belt guard, to do so release retaining
clips.
– Unscrew the screws for the cylinder head cover in the se‐
quence -13 ... 1- and remove cover.
Installing
Installation occurs in reverse order to removal. Pay attention to
the following:
WARNING
Wear protective gloves and goggles when working with gasket
remover and degreasing agent!
– Clear sealing surface on bearing cap and on cylinder head
from sealant residues with chemical gasket remover.
– Degrease the sealing surfaces.
– Apply on both edges on the sealing surfaces of the bearing
cap/cylinder head -arrows- at front ...
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
84
Rep. gr.15 - Cylinder head, valve gear
⇒ page 13 .