Skoda Octavia II 2004 Workshop Manual page 238

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
❑ Separation point
❑ Installing the exhaust system without tension
17 - 23 Nm
18 - Front clamping sleeve
❑ align exhaust system free of stress before fitting on
❑ Tighten screwed connections uniformly
19 - Retaining strap
❑ Replace if damaged.
❑ Pay attention to the part number
20 - Rear tunnel bridge
21 - Shackle
22 - Middle part of exhaust system
❑ for first equipment building unit with rear part of exhaust gas system, replace individually when carrying
out repairs
❑ Separation point
❑ Installing the exhaust system without tension
23 - Rear clamping sleeve
❑ Note installation position:
❑ Tighten screwed connections uniformly
24 - from exhaust turbocharger
25 - Warm-type clamp - 7 Nm
❑ replace
26 - Gasket
❑ replace
❑ Check fitting position
27 - 23 Nm
28 - Mounting bracket
❑ screwed onto the cylinder block
29 - 8 Nm
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
232
Rep. gr.26 - Exhaust system
⇒ page 238
⇒ page 238
⇒ page 238 .
⇒ page 239
⇒ page 239
⇒ page 239