Removing And Installing The Radiator For Engines With Code Bmm - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
– Remove connecting hose on left; to do so, slightly lift retaining
clips -arrows-.
– Disconnect plug connection -1-.
– Remove screws -arrows- and take out fan shroud downwards.
Installing
Installation occurs in reverse order to removal. Pay attention to
the following:
♦ Tightening torques:
1.12 Removing and installing the radiator for
engines with code BMM
Special tools and workshop equipment required
♦ Catch pan for workshop cranes , e.g. -VAS 6208-
♦ Pliers for spring-type clips
Removing
– Switch off ignition and pull out ignition key.
Note
Collect drained coolant in a clean container for proper disposal or
reuse.
– Remove fan shroud for radiator fan - V7- and right radiator fan
- V35 - ⇒ page 145
– Drain coolant ⇒ page 143
– Place a catch pan under the engine.
– Remove coolant hose between engine and radiator -arrows-.
146
Rep. gr.19 - Cooling
⇒ page 139
.
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�