Installing Engine - Skoda Octavia II 2004 Workshop Manual

WARNING
Use securing pins on the hooks and rig pins to prevent release.
– Attach lifting device - MP 9-201- at engine and at workshop
crane , e.g. -V.A.G 1202A- .
Belt pulley side: 2nd hole of the extension in Position 1.
Flywheel side: 2nd hole of the extension in Position 8.
– Lift engine with assembled engine mount - T10012- out of the
engine/gearbox jack using the workshop crane .
– Remove engine mount - T10012 - .
– To carry out assembly work, use the engine bracket - MP
1-202- , adapter - MP 1-202/10- and bushing - T30010 - to
secure the engine to the assembly stand - MP 9-101- ; (the
illustration shows the 1.9 l/47 kW SDI engine; attachment is
identical).
1.3

Installing engine

Installation occurs in reverse order to removal. Pay attention to
the following:
Note
When performing installation work replace the self-locking
♦
nuts.
Replace screws which have been tightened to a torquing angle
♦
as well as sealing rings and seals.
Fit all cable straps on again in the same place when installing.
♦
Secure all hose connections with corresponding hose clips.
♦
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability Caution
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
When undertaking all installation work, particularly in the en‐
gine compartment because of its cramped construction, please
observe the following:
♦ Lay lines of all kinds (e.g. for fuel, hydraulic fluid, cooling
fluid and refrigerant, brake fluid, vacuum) and electrical
lines in such a way that the original line guide is re-estab‐
lished.
♦ To avoid damage to lines/wiring, ensure sufficient clear‐
ance to all moving or hot components.
Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
1. Removing and installing engine
15