Skoda Octavia II 2004 Workshop Manual page 77

❑ pay attention to order for slackening
❑ Pay attention to sequence and procedure when tightening
18 - Multipin plug connection
❑ central for unit injectors
❑ When removing from bearing bush, disconnect plug connection by turning anti-clockwise
19 - Gasket
❑ replace
20 - Tandem pump
❑ Removing and installing
❑ Check ⇒ page 174
21 - 20 Nm
22 - Cylinder head
❑ Removing ⇒ page 74
❑ check for distortion
❑ installing ⇒ page 77
❑ After replacing, fill with fresh coolant
23 - Mixing tube
❑ inserted into cylinder head
❑ pull out with hook
❑ Installation position of mixing tube
24 - Cylinder head gasket
❑ Replace ⇒ page 74
❑ Pay attention to the marking
25 - Hall sender - G40-
❑ for camshaft position
Installation position of mixing tube
The recess on the mixing tube points upwards -arrow-,
Checking cylinder head for distortion
⇒ page 74
⇒ page 171
⇒ page 71
⇒ page 135
⇒ page 71
⇒ page 72
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
⇒ page 78
1. Removing and installing cylinder head
71