Removing And Installing Valve Levers For Engines With Code Bkd, Azv - Skoda Octavia II 2004 Workshop Manual

– Turn the adjusting screw in the opposite direction from the stop
by about 180°
– Firmly hold the adjusting screw in this position and tighten the
locknut to 30 Nm.
– Install cylinder head cover
– Install battery ⇒ Electrical System ⇒ Rep. gr. 27 .
– Install the mounting bracket and radiator for exhaust gas re‐
circulation with radiator flap
– Install bulkhead plenum chamber and plenum chamber cover
⇒ Body Work ⇒ Rep. gr. 66 .
Note
After installing the camshafts, the engine must not be cranked
♦
or started for about 30 minutes. The valve lever with hydraulic
valve clearance compensation must settle (otherwise the
valves would strike the pistons).
After carrying out work on the valve gear, carefully crank en‐
♦
gine at least 2 revolutions to ensure that no valve touches the
piston when the engine is started.
2.5 Removing and installing valve levers for
engines with code BKD, AZV
Special tools and workshop equipment required
♦ Extractor - T10133/3-
Note
Replace O-rings.
♦
Do not mix up the old valve levers
♦
Remove valve levers for outlet valves
– Remove the camshafts
– Drain coolant ⇒ page 135
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
– Remove the connecting pipe between the mechanical exhaust
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
gas recirculation valve and the flap of the radiator for exhaust
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
gas recirculation ⇒ page 241
– Remove the connecting piece for coolant from the cylinder
head ⇒ page 131 .
⇒ page 69 .
⇒ page 241 .
⇒ page 98 .
.
.
Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
105
2. Repairing Valve Gear