Skoda Octavia II 2004 Workshop Manual page 220

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
– Insert new fixing screws and carefully screw in without a lot of
force using the plug insert - T10054- as far as the stop
-arrow-.
Caution
If the unit injector is pulled downwards by the fixing screws,
there is a risk of the unit injector being drawn into the seat at
an angle. This could lead to driving behaviour errors and start‐
ing difficulties. Therefore, the unit injector must only be
screwed on once it has been pressed into its seat.
– Position the valve lever - VW 541/1 A- with thrust piece - VW
541/5- .
– Carefully press the unit injector with valve lever into the seat
and hold with the same force.
– Carefully screw in the fixing screws of the unit injector without
a lot of force as far as the stop.
– Alternately tighten the unit injector screws -arrows- using plug
insert - T10054- as follows:
Stage
I – Tighten with the torque wrench to 3 Nm.
II – Using a rigid wrench torque a further 270° (
turn).
Note
Further torquing angle 270° must be carried out in one go!
– Before inserting the valve-lever shaft, check that all ball studs
-1- and O-rings -2- have been inserted in the unit injectors.
214
Rep. gr.23 - Mixture preparation - injection
Apply
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
3
/ 4