Removing And Installing Cylinder Head Cover For Engines With Code Bkd, Azv - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
Special tools and workshop equipment required
♦ Feeler gauges
♦ Knife-edge straightedge
– Inspect cylinder head at several points for distortion using a
knife-edge straightedge and feeler gauge.
• Max. permissible distortion: 0,05 mm
Note
It is not permissible to rework the cylinder heads of diesel engines.
Identification of the cylinder head gasket
♦ Part number = -arrow 1-
♦ Control code = -arrow 2- (ignore)
♦ Bores = -arrow 3-
Note
Differing thicknesses of cylinder head gaskets are inserted ac‐
cording to the piston projection. If only the gasket is replaced, it
must be replaced with a new gasket with the same marking.
1.2 Removing and installing cylinder head
cover for engines with code BKD, AZV
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
Removing
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
– Remove engine cover
– Pull off hose -3-.
– Unscrew screws -1- and -2- and loosen holder -3- for fuel ho‐
ses on left engine lifting eye.
Note
Coolant hoses as well as fuel lines remain connected.
72
Rep. gr.15 - Cylinder head, valve gear
⇒ page 13 .