Removing And Installing Fuel Gauge Sender G169 On Vehicles With Four-Wheel Drive - Skoda Octavia II 2004 Workshop Manual

1.11 Removing and installing fuel gauge
sender - G169- on vehicles with four-
wheel drive.
•
The fuel tank must not be more than
Note
Where necessary, empty the fuel tank
♦
Safety precautions when working on the fuel supply system
♦
⇒ page 3 .
Observe the regulations concerning cleanliness when working
♦
on the fuel supply/injection system
Make sure that the sender for fuel gauge display is not bent.
♦
Removing
– Switch off ignition and pull out ignition key.
– Removing rear seat bench ⇒ Body Work ⇒ Rep. gr. 72 .
– Remove left cover and disconnect plug from fuel gauge sender
2 - G169- .
– Open lock ring with the wrench - T30101 - .
– Pull lightly Fuel gauge transmitter 2 - G169- out of the opening
of the fuel tank, unlock the securing tabs -arrows- and discon‐
nect the pump.
Installing
Installation occurs in reverse order to removal. Pay attention to
the following:
WARNING
When installing do not bend the float arm of the fuel gauge
sender 2 - G169- .
– Insert the fuel gauge sender 2 - G169- into the fuel tank.
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
1
/ 2 full.
⇒ page 155 .
⇒ page 4 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
1. Removing and installing parts of the fuel supply system
Octavia II 2004 ➤ , Octavia II 2010 ➤
169