Skoda Octavia II 2004 Workshop Manual page 16

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
– Release screw -1- by one turn.
– Release screw -2- and nut -3-.
– Take out fuel filter with connected hoses and lay to the side.
Continued for all vehicles
– Remove V-ribbed belt
– Remove alternator ⇒ Electrical System ⇒ Rep. gr. 27 .
Vehicles with air conditioning
WARNING
Do not open the refrigerant circuit of the air conditioning sys‐
tem.
Note
In order to avoid damage to the AC compressor as well as to the
refrigerant lines and hoses, ensure that the lines and hoses are
not over-tensioned, kinked or bent.
– Remove AC compressor from the bracket for auxiliary units
⇒ page 23 .
– Tie up removed AC compressor with connected refrigerant
hoses to the body.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Vehicles with auxiliary heating
– Disconnect the necessary connections at the coolant pipes
and at the coolant shut-off valve of heating system - N279- .
– Only remove long exhaust pipe of auxiliary heater ⇒ Heating,
air conditioning ⇒ Rep. gr. 82 ,
Continued for all vehicles
– Remove charge air hoses and charge air pipe between engine
and charge air cooler:
♦ Motor code BKD, AZV:
♦ Engine code BMM:
Caution
Shut off the openings of the charge air cooler, e.g. with a clean
piece of foam, so that no coolant can get in.
– Remove fan shroud and radiator.
♦ Motor code BKD, AZV:
♦ Engine code BMM:
– Remove holder of the wire for oil level and oil temperature
sender - G266- from assembly carrier.
10
Rep. gr.10 - Removing and installing engine
⇒ page 23 .
⇒ page 191
⇒ page 196
⇒ page 138
⇒ page 146