Skoda Octavia II 2004 Workshop Manual page 110

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
– Replace screws -1, 3, 5, 7, 9-.
– Tighten screws -1 ... 20- evenly and in the specified order from
inside to outside. Tightening torque 20 Nm.
– Insert valve-lever shaft.
– Continue turning in valve-lever shaft screws -1 ... 5- by 90° in
the specified order (
– Insert central plug connection for unit injectors and for glow
plugs ⇒ page 206 .
– Install camshaft sealing rings
– Install tandem pump
– Install hub and camshaft sprockets
– install toothed belt and set the timing
– Place a dial gauge on the adjusting screw of the unit injector.
Caution
The engine may only be turned in the direction of engine rota‐
tion (clockwise) at the crankshaft.
– Turn the crankshaft in the running direction of the engine until
the roller of the valve lever is on the drive cam tip.
• Valve lever roller side -arrow A- is at the highest point.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
• Dial gauge -arrow B- is at the lowest point. with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
– Remove the dial gauge.
– Turn the adjusting screw into the valve lever until clear resist‐
ance can be felt (the unit injector is at the stop).
104
Rep. gr.15 - Cylinder head, valve gear
1
/ 4 turn).
⇒ page 97 .
⇒ page 171 .
⇒ page 23
⇒ page 26
.
.