Skoda Octavia II 2004 Workshop Manual page 64

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
The fitting position of the rotor on the crankshaft is accurate if
there is a distance -a- of 0.5 mm between the crankshaft flange
-A- and the rotor -B-.
– Position the steel straight edge onto the crankshaft flange.
– Measure the distance between the steel straightedge and the
rotor with a feeler gauge.
If the measured distance is less than 0.5 mm:
– Press down rotor ⇒ page 58
If the dimension is correct:
– Tighten the new fixing screws of the sealing alternately cross‐
wise.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
Tightening torque: 15 Nm.
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
– Install engine speed sender - G28- -1-. Tightening torque: 5
Nm.
– Installing the oil pan
– Installing intermediate plate.
– Install flywheel with new screws. Tighten fixing bolts to 60 Nm
and torque a further
E - Pressing down the rotor
– Screw assembly tool - T 10134- with Allan screws up to the
stop onto the crankshaft flange.
– Screw in three knurled screws -B- into the flange.
– Subsequently insert the guide bolt with black ball -D- fully into
the threaded bore of the crankshaft. If the guide bolt is correctly
positioned, then the handle has a distance of approx. 10 mm
from the assembly cup -C-.
– Screw in hexagon nut -E- by hand onto the threaded spindle
until it rests against the assembly cup.
58
Rep. gr.13 - Crankshaft group
.
⇒ page 125 .
1
/ 4 turn (90°).