Skoda Octavia II 2004 Workshop Manual page 243

– Release screws -arrows- at holder for diesel particle filter.
– Slacken nuts of front clamping sleeve.
– Unscrew hanger of exhaust system -arrows-.
Note
For the following working steps a 2nd mechanic is required.
♦
The decoupling element in the pre-exhaust pipe should not be
♦
bent by more than 10° - risk of damage.
When removing the diesel particle filter slightly raise the heat
♦
shield, in order to avoid damage.
– Remove the pre-exhaust pipe with diesel particle filter by turn‐
ing clockwise 180°; to do so slightly push the engine/gearbox
assembly towards the front.
Vehicles with four-wheel drive
– Remove assembly carrier with steering gear ⇒ Chassis ⇒
Rep. gr. 40 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
– Remove propshaft from gearbox ⇒ Gearbox ⇒ Rep. gr. 39
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
and secure it to the left on the body.
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
– Remove fixing clamp -1- for diesel particle filter.
– Disconnect plug -arrow- and remove exhaust gas pressure
sensor 1 - G450 - with pressure lines.
Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
1. Removing and installing parts of the exhaust system
237