Removing And Installing Sealing Flange And Flywheel - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
2 Removing and installing sealing
flange and flywheel
Note
Repairs to the clutch ⇒ gearbox ⇒ Rep. gr. 30 .
1 - Sealing ring
❑ Replace ⇒ page 49
❑ do not oil or grease
2 - Sealing flange on the belt
pulley side
❑ must be positioned on
dowel sleeves
❑ Removing and installing
⇒ page 51
3 - Cylinder block
4 - Dual-mass flywheel
❑ Removing and installing
⇒ page 59
❑ assembly is only possi‐
ble in one position
through offset holes
5 - 60 Nm + torque a further 90°
1
( / 4 turn)
❑ replace
6 - Intermediate plate
❑ must be positioned on
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
dowel sleeves
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
❑ do not damage/bend
during assembly work
❑ hang on the sealing
flange ⇒ page 49
7 - 15 Nm
❑ replace
8 - Sealing flange on the gear‐
box side
❑ can only be replaced
complete with gasket ring and with rotor of engine speed sender - G28-
❑ Replace ⇒ page 53
9 - engine speed sender - G28-
❑ Removing and installing
10 - 5 Nm
48
Rep. gr.13 - Crankshaft group
⇒ page 226