Checking The Axial Play Of The Camshaft For Engines With Code Bmm - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
❑ Pay attention to sequence for loosening and tightening
9 - Washer
❑ for cylinder head screws
❑ before installing the bearing caps, insert into the cylinder head
10 - Hydraulic bucket tappets
❑ Check ⇒ page 118
❑ Removing and installing
❑ do not mix up (mark)
❑ lay aside with contact surface facing down
❑ before installing check axial play of the camshaft
❑ oil contact surfaces
11 - Valve collets
12 - Valve spring plate
13 - Valve spring outside
❑ Removing and installing
14 - Valve spring inside
❑ Removing and installing
15 - Valve stem gasket
❑ Replace ⇒ page 119
16 - Valve guide
❑ Check ⇒ page 121
17 - The unit injector
❑ Removing and installing
18 - Sealing ring
❑ Replace ⇒ page 113
19 - Valve
❑ Valve dimensions
❑ do not rework, only grinding in is permissible
2.10 Checking the axial play of the camshaft
for engines with code BMM
Special tools and workshop equipment required
♦ Universal dial gauge bracket - MP 3-447 (VW 387)-
♦ Dial gauge
Test sequence
– Perform measurement with the bucket tappets removed and
the first and last bearing cap fitted.
• Wear limit: max. 0,15 mm
112
Rep. gr.15 - Cylinder head, valve gear
⇒ page 119
⇒ page 119
⇒ page 119
⇒ page 221
⇒ page 121
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
⇒ page 115
⇒ page 112