Skoda Octavia II 2004 Workshop Manual page 35

17 - 10 Nm
❑ insert using locking agent - D 000 600 A2-
18 - O-ring
❑ replace
19 - Coolant pump
❑ Removing and installing
20 - 15 Nm
21 - Crankshaft toothed belt sprocket
❑ there must not be any oil present on the contact surface between the pulley and the crankshaft
❑ can be installed only in one position
22 - Large guide pulley
23 - Screw for guide pulley
❑ replace
❑ different screws for vehicles with smaller or larger engine support
❑ Tightening torque:
♦ Vehicles with smaller engine support:
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
♦ Vehicles with larger engine support:
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Tensioning pulley
Additional hole in the eccentric of the tensioning pulley for 6 mm
hexagon socket wrench -arrow-.
Note
The tensioner pulley of the new version can be adjusted with the
special two-hole nut turner , e. g. -T10020- , or using a commer‐
cially available 6 mm hexagon socket wrench.
Adjust TDC for cylinder 1 with vibration damper installed
– Turn the crankshaft in the direction of engine rotation at the
central screw so that the notch on the vibration damper (TDC
marking for cylinder 1) -large arrow- is in line with the em‐
bossed arrow -small arrow- on the middle toothed belt guard
as shown.
Use the mirror to do this.
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
⇒ page 147
⇒ page 24
⇒ page 25
Octavia II 2004 ➤ , Octavia II 2010 ➤
1. Disassembling and assembling engine
29