Skoda Octavia II 2004 Workshop Manual page 200

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
18 - Hollow screw - 60 Nm
19 - Countersupport
❑ for exhaust gas turbocharger
❑ for oil return-flow line
20 - Exhaust gas temperature sender 1 - G235- ( Temperature sender upstream of turbocharger - G507- )
❑ 45 Nm
❑ the thread of new temperature transmitters must be coated with assembly paste
❑ Grease only the thread with hot bolt paste - G 052 112 A3- for re-used temperature sender.
21 - Heat shield
22 - Supports
❑ for intake hose on exhaust gas turbocharger
23 - 9 Nm
24 - 10 Nm
Special tools and workshop equipment required
♦ Set of tools SW 17 - T10395-
♦ Pliers for spring-type clips
Caution
In case of mechanical damage to the exhaust gas turbocharg‐
er, e.g. damage of the compressor wheel, it is not sufficient to
only replace the exhaust gas turbocharger. In order to prevent
consequential damage to the engine, perform the following
tasks:
♦ Clean all oil lines.
♦ Change engine oil and oil filter.
♦ Check air filter housing, air filter element and charge air
pipes as well as charge air hoses for soiling.
♦ Check all the air guides and the charge air cooler for for‐
eign bodies.
If foreign bodies are detected in the charge air system, the
complete charge-air routing must be cleaned and if necessary
the charge air cooler must also be replaced.
Removing
– Switch off ignition and pull out ignition key.
194
Rep. gr.21 - Turbocharging/supercharging
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�