3
Crankshaft, Piston and Conrod
3.1
Removing and installing crankshaft
Note
The engine should be attached to the engine repair stand with the
engine holder - MP 1-202 (VW 540)- for carrying out removal and
installation work.
1 - Bearing shell
❑ for cylinder block with lu‐
bricating groove
❑ do not mix up used bear‐
ing shells (mark)
2 - Drive chain sprocket
❑ for oil pump
❑ Removing and installing
⇒ page 62
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
3 - Bearing shell
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
❑ for bearing cap without
lubricating groove
❑ do not mix up used bear‐
ing shells (mark)
4 - Thrust washers
❑ for bearing 3
❑ different versions for
bearing cap and cylin‐
der block
❑ pay attention to locating
element
5 - 65 Nm + torque a further 90°
1
(
/ 4 turn)
❑ replace
6 - Bearing caps
❑ Bearing cap 1: belt pul‐
ley side
❑ bearing cap 3 with re‐
cesses for thrust wash‐
ers
❑ retaining lugs of the
bearing shells of the cyl‐
inder block/bearing cap must be on top of one another
7 - Needle bearing
❑ only vehicles with automatic gearbox
❑ Replace
⇒ page 62
8 - Crankshaft
❑ with chain sprocket for oil pump drive
❑ Axial play when new: 0.07...0.17 mm, wear limit: 0.37 mm
❑ Crankshaft bearing pin: ∅ 54.00 mm
Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
3. Crankshaft, Piston and Conrod
61