Exhaust System; Removing And Installing Parts Of The Exhaust System; Summary Of Components For Engines With Code Bkd, Azv - Skoda Octavia II 2004 Workshop Manual

26 –

Exhaust system

1 Removing and installing parts of the
exhaust system
Note
The decoupling element in the pre-exhaust pipe should not be
♦
bent by more than 10° - risk of damage.
Replace the gaskets and the self-locking nuts.
♦
When performing installation work on the exhaust system,
♦
make sure the exhaust system is not mounted under tension
and has adequate clearance from the vehicle body. If
necessary ,slacken the clamping sleeve and align the silenc‐
ers and exhaust pipe so as to create adequate clearance
between these components and the vehicle body, and to en‐
sure that the weight of the exhaust system is evenly distributed
over the hangers.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
1.1

Summary of components for engines with code BKD, AZV

with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
1 - Rear tunnel bridge
2 - Middle part of exhaust sys‐
tem
❑ for first equipment build‐
ing unit with rear part of
exhaust gas system, re‐
place individually when
carrying out repairs
❑ Separation point
⇒ page 238
❑ Installing the exhaust
system without tension
⇒ page 239
3 - Retaining strap
❑ Replace if damaged.
❑ Pay attention to the part
number
4 - Shackle
5 - 23 Nm
6 - Shackle
7 - Warm-type clamp - 7 Nm
❑ replace
8 - Gasket
9 - Exhaust pipe
❑ with catalytic converter
❑ protect against shocks
and blows
❑ with decoupling element
❑ do not twist decoupling
element more than 10° -
risk of damage
Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018

1. Removing and installing parts of the exhaust system

229