Skoda Octavia II 2004 Workshop Manual page 84

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
– Pay attention to the identification of the cylinder head seal.
♦ Part number = -arrow 1-
♦ Control code = -arrow 2- (ignore)
♦ Bores = -arrow 3-
Note
If the cylinder head gasket or cylinder head are replaced, then
♦
install a new cylinder head gasket with the same identification
-arrow 3-.
If parts of the crankshaft drive were replaced, then the new
♦
cylinder head gasket must be redefined by measuring the pro‐
trusion of the piston in TDC.
– Fit on cylinder head gasket.
• Pay attention to dowel sleeves -arrows- in cylinder block.
• Observe the installed position of the cylinder head gasket, the
marking "above" or the part number must point to the cylinder
head.
– Insert the cylinder head.
– Insert new cylinder head bolts and tighten by hand.
– Tighten the cylinder head in four stages in the indicated tight‐
ening sequence:
Stage
I – Tighten with the torque wrench to 40 Nm.
II – Tighten with the torque wrench to 60 Nm.
III – Using a rigid wrench torque a further 90° (
turn).
IV – Using a rigid wrench torque a further 90° (
turn).
Note
Tightening up the cylinder head bolts after doing repair work is
not necessary.
78
Rep. gr.15 - Cylinder head, valve gear
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Apply
1
1
/ 4
/ 4