Removing And Installing The Exhaust Gas Turbocharger For Engines With Code Bmm - Skoda Octavia II 2004 Workshop Manual

2.3 Removing and installing the exhaust gas turbocharger for engines with code
BMM
1 - 10 Nm
2 - Mounting bracket
3 - Heat shield
4 - Oil supply hose
❑ to connection fitting of
oil feed line for exhaust
turbocharger
❑ Check oil feed line for
continuity before instal‐
ling.
❑ Fill the exhaust turbo‐
charger with engine oil
through the connection
fitting of the oil feed line
before installing
5 - Vacuum setting element
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
❑ for charge pressure
control
❑ Component part of the
exhaust turbocharger,
not replaced separately
6 - Vacuum hose
7 - Gasket
❑ replace
❑ Check fitting position
8 - for diesel particle filter
9 - Warm-type clamp - 7 Nm
❑ for exhaust gas turbo‐
charger and diesel par‐
ticle filter
❑ replace
10 - Exhaust turbocharger with exhaust manifold
❑ can only be replaced as one part
❑ Removing and installing
11 - 25 Nm
❑ replace
12 - 25 Nm
13 - Gasket
❑ replace
14 - Connecting pipe
❑ for exhaust gas recirculation
15 - 25 Nm
❑ replace
16 - 15 Nm
17 - O-ring
❑ replace
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
⇒ page 194
Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
2. Charge-air system with exhaust gas turbocharger - Part 2
193