Skoda Octavia II 2004 Workshop Manual page 49

– Release screws -1 ... 3- for engine support and remove sup‐
port.
Note
To release the screws for the engine support, raise or lower en‐
gine slightly via the spindle of supporting device - T30099- .
Continued for all vehicles
Caution
The engine may only be turned in the direction of engine rota‐
tion (clockwise) at the crankshaft.
– Rotate crankshaft to TDC for cylinder 1.
• The gear segment -arrow- must point upwards.
– Lock hub with locking pin - 3359- .
– Depending on the version, lock the crankshaft toothed belt
sprocket using the crankshaft arrester - T10050- or crankshaft
arrester - T10100- .
Distinguishing the crankshaft toothed belt sprocket:
A = original version of toothed belt sprocket with circular tooth
flanks, rectangular TDC marking on tooth in 12 o'clock position
for cylinder 1 - use crankshaft arrester - T10050 -
B = new version of toothed belt sprocket with elliptical tooth flanks,
triangular TDC marking on the gap in the sprocket in 1 o'clock
position - use crankshaft arrester - T10100-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
1. Disassembling and assembling engine
43