Skoda Octavia II 2004 Workshop Manual page 236

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
❑ Installing the exhaust system without tension
10 - Countersupport
11 - 40 Nm
12 - Front clamping sleeve
❑ align exhaust system free of stress before fitting on
❑ Tighten screwed connections uniformly
13 - 23 Nm
14 - Front tunnel bridge
15 - 20 Nm
16 - Rear clamping sleeve
❑ Note installation position:
❑ Tighten screwed connections uniformly
17 - Rear part of exhaust system
❑ for first equipment building unit with middle part of exhaust gas system, replace individually when carrying
out repairs
❑ Separation point
❑ Installing the exhaust system without tension
18 - Shackle
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
230
Rep. gr.26 - Exhaust system
⇒ page 238 .
⇒ page 238
⇒ page 239
⇒ page 239
⇒ page 239