Skoda Octavia II 2004 Workshop Manual page 27

– Position supporting device - T30099- and base - T30099/1-
and support the engine/gearbox unit in its installed position.
– Uniformly pre-tension the engine/gearbox unit with both spin‐
dles, but do not raise.
– Release the screws -arrows- of the assembly bracket at the
engine.
– Slightly loosen the screws -2- of the unit mounting at the gear‐
box (less than 1 revolution).
– Successively replace all the screws of the assembly bracket
(as long as it has not already been performed when installing
the engine) and insert these loosely.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
1. Removing and installing engine
21