Glow Plug System; Removing And Installing The Glow Plugs For Engines With Code Bkd, Azv; Checking The Glow Plugs For Engines With Code Bkd, Azv; Removing And Installing The Glow Plugs For Engines With Code Bmm - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
28 –

Glow plug system

1 Glow Plug System
1.1 Removing and installing the glow plugs
for engines with code BKD, AZV
Special tools and workshop equipment required
♦ Insertion tool 8 mm
Removing
– Switch off ignition.
– Remove cylinder head cover
– Unplug connector from glow plugs.
– Remove glow plugs using plug insert -arrow-.
Installing
Installation occurs in reverse order to removal. Pay attention to
the following:
– Install glow plugs and tighten to 10 Nm.
– Install cylinder head cover
1.2 Checking the glow plugs for engines
with code BKD, AZV
Glow plugs can be checked in "guided fault finding" with the ve‐
hicle diagnosis, measurement and information system - VAS
5051- .
1.3 Removing and installing the glow plugs
for engines with code BMM
Special tools and workshop equipment required
♦ Flexible-head wrench e.g. -3220 -
Removing
– Switch off ignition.
– Remove engine cover
250
Rep. gr.28 - Glow plug system
⇒ page 72 .
⇒ page 72 .
⇒ page 13 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�