Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
– Unplug connector of the glow plugs -1-. Fixing screws -2-, un‐
screw the stainless steel clamps and remove the entire wiring
harness.
Installing
Installation occurs in reverse order to removal. Pay attention to
the following:
– Expose wiring harness and tighten fixing screws to 10 Nm.
– Insert central plug connection through the opening in the bear‐
ing frame. In doing so, make sure that the locking clips
-arrows- are in the correct position.
– Position the reduction ring (colour-coded "long" lug -arrow- is
in the 12 o'clock position).
– Place key - T10310- on the reduction ring and secure the ring
with a torquing angle of 90 ° (
to the -arrow direction-.
Note
After correct installation of the reduction ring, the colour-coded
"short" lug is in the 12 o'clock position.
– Place central plug connection on cylinder head and lock.
– Install cylinder head cover
1.5
Removing and installing the air filter for engines with code BKD, AZV
208
Rep. gr.23 - Mixture preparation - injection
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
1
/ 4 turn) in the opposite direction
⇒ page 72
.