Separating New Connecting Rod - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
2.0/100; 103 kW TDI PD Engine - Edition 01.2018
Identification of the cylinder head gasket
♦ Part number = -arrow 1-
♦ Control code = -arrow 2- (ignore)
♦ Bores = -arrow 3-
Note
Differing thicknesses of cylinder head gaskets are inserted
♦
according to the piston projection. When replacing the seal,
use a new seal with the same marking -arrow 3-.
If different values are measured during the projection meas‐
♦
urement of the piston, the greatest dimension applies for the
seal assignment.
Note
If different values are measured during the projection measure‐
ment of the piston, the greatest dimension applies for the seal
assignment.
3.6

Separating new connecting rod

It can happen that on new conrods, the provided separation point
is not completely cracked. If the conrod bearing cap cannot be
removed by hand, proceed in the following manner:
– Mark the assignment of the connecting rod to the cylinder.
– Slightly clamp the conrod, as shown in the illustration, in a vice
with aluminium protective jaws.
Note
Only tension the conrod slightly in order to avoid damage on
♦
the conrod.
The conrod is clamped below the broken line.
♦
– Unscrew both screws -arrows- by approx. 5 turns.
– Knock against the conrod bearing cap with a plastic hammer
in -direction of arrow- in order to loosen it.
68
Rep. gr.13 - Crankshaft group
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�