Removing And Installing Flywheel; Removing And Installing The Sealing Flange On The Gearbox Side - Skoda Octavia III 2013 Workshop Manual

Sealing flange on the gearbox side - tightening torque and tight‐
ening order
– Tighten screws in steps as follows:
Stage Bolts
1. -1 ... 6-
2. -1 ... 6-
Installing intermediate plate
– Insert intermediate plate on sealing flange -top arrow- and
push onto the dowel sleeves -bottom arrows-.
2.2

Removing and installing flywheel

Special tools and workshop equipment required
♦ Counterholder - MP1-223 (3067)-
Removing
• Gearbox removed
– Insert the counterholder - 3067- into the hole on the cylinder
block -B-.
– Loosen and remove all flywheel bolts.
Install
Install in the reverse order of removal. When doing this, note the
following:
Note
Replace screws which have been tightened firmly to a torque‐
♦
ing angle.
Assembly of flywheel is only possible in one position.
♦
– Insert the counterholder - 3067- into the hole on the cylinder
block -A-.
Tightening torques
♦ Screw for flywheel
⇒ "2.1 Gearbox side cylinder block - Summary of compo‐
nents", page 56
2.3 Removing and installing the sealing
flange on the gearbox side
Special tools and workshop equipment required
Octavia III 2013 ➤ , Octavia III 2014 ➤ , Yeti 2010 ➤ , Yeti 2011 ➤
Tightening torque
by hand as far as the stop
tighten crosswise in steps up to 10 Nm
1.6/81 kW MPI engine - Edition 06.2014
2. Cylinder block, gearbox end
57